- 18 Мар 2025
- 29
- 20
Всем доброго времени суток!
Здесь можно заказать корректировку (пересчет) контрольной суммы (checksum) файла прошивки ЭБУ после внесения в него изменений.
Услуга ПЛАТНАЯ. 1 файл прошивки ЭБУ (корректировка 1-го файла прошивки после калибровки) - 10 USDT.
На выходе вы получаете готовый для заливки (записи в блок ЭБУ) файл с уже скорректированной контрольной суммой.
Присылайте оригинальный файл (оригинальный дамп) и файл с новыми калибровками (после тюна) - т.е. ожидается, что вы пришлете в своем сообщении 2 файла.
Я их смотрю и пишу, можно ли их сделать. Список поддерживаемых блоков довольно большой.
Здесь можно заказать корректировку (пересчет) контрольной суммы (checksum) файла прошивки ЭБУ после внесения в него изменений.
Услуга ПЛАТНАЯ. 1 файл прошивки ЭБУ (корректировка 1-го файла прошивки после калибровки) - 10 USDT.
На выходе вы получаете готовый для заливки (записи в блок ЭБУ) файл с уже скорректированной контрольной суммой.
Присылайте оригинальный файл (оригинальный дамп) и файл с новыми калибровками (после тюна) - т.е. ожидается, что вы пришлете в своем сообщении 2 файла.
Я их смотрю и пишу, можно ли их сделать. Список поддерживаемых блоков довольно большой.
Good day, everyone!
Here you can request a correction of the CHECKSUM for your ECU firmware dump files after tuning (after remapping in WinOLS and other tuning software).
This is a PAID service. 1 ECU firmware file will cost you 10 USDT.
After I finish my part, you will receive your calibrated file with a corrected (correct) checksum, ready for uploading into the ECU.
You just need to post here an original fine (ORI / STOCK dump) and a tuned file (no matter what you did to a file - what calibrations you did).
I will check them and will tell you if I can do them.
The list of supported ECUs is quite big.
Wishing you all the best in your tuning journey! I am here to support you in your efforts.
Here you can request a correction of the CHECKSUM for your ECU firmware dump files after tuning (after remapping in WinOLS and other tuning software).
This is a PAID service. 1 ECU firmware file will cost you 10 USDT.
After I finish my part, you will receive your calibrated file with a corrected (correct) checksum, ready for uploading into the ECU.
You just need to post here an original fine (ORI / STOCK dump) and a tuned file (no matter what you did to a file - what calibrations you did).
I will check them and will tell you if I can do them.
The list of supported ECUs is quite big.
Wishing you all the best in your tuning journey! I am here to support you in your efforts.