Help on Reset adblue countdown after nox sensor change using DTS Monaco

[Klovis7512]

Hi
I need help on how to reset the AdBlue countdown after I have replaced the downstream nox sensor on my 2016 Mercedes X253 (GLC) 220d.
I have Xentry offline, DTS, Vediamo, cbf and smr-d files. I have managed to unlock ecu in DTS, but dont find the right diagnostic routines to run in order to reset the warning scenarion and countdown. The faultcodes that are set, and not possible to clear, are: 13E400, 2BA9FD and 1BC300. No codes on the SCR module. Adblue pump and injector are checked ok.
BR
Henrik

 

[Sensan]

Hallo.
Warnscenario Reset,
Reset Adblue inducement system for EOL

 

[Auto-4iP]

Hallo, 2022 Sprinter 907. AdBlue is blocked in the MRD1 control unit. What commands are used to unblock it in the Monaco?

 

[Sensan]

Unlock the access code in the ignition switch and in the engine control unit. Then carry out the commands I mentioned earlier. It is very important that there are no errors in the AdBlue control unit

 

[Auto-4iP]

Unlock the access code in the ignition switch and in the engine control unit. Then carry out the commands I mentioned earlier. It is very important that there are no errors in the AdBlue control unit

If there are errors, the reset will not be felt ?

 

[Sensan]

If there are errors, the reset will not be felt ?

no. There should be no errors in the AdBlue control unit.

 

[bergut]

Пишите по русскому, форум создан на русском